Cart Total: $0
View Cart | Checkout

     HOME > FITTINGS | ALL CHOICES > Brass Fittings > Needle Valves | Flare & Compression

Needle Valves | Flare & Compression

Needle Valves | Brass Flare & Compression

PICTORIAL LANDING PAGE; Select your Needle Valve by clicking button below, Or Use The Sidebar Menu.
Compression Needle Valves Brass Compression x MPT Needle Valves Brass Compression x MPT 90° Needle Valves Brass MPT Needle Valves Brass
Flare x Flare Needle Valves Brass Flare x MPT Needle Valves Brass Flare x MPT 90° Needle Valves Brass FPT x FPT Needle Valves Brass FPT x MPT Needle Valves Brass
Images are for illustration purposes only-body shapes may vary from actual inventory.
More About Needle Valves Needle Valves have a slender, tapered point at the end of the valve stem that is lowered through the seat to restrict or block flow. Fluid flowing through the valve turns 90° degrees and passes through an orifice that is the seat for a rod with a cone shaped tip. These needle valves are widely used to accurately regulate the flow of liquids and gases at low flow rates. The fine threading of the stem and the large seat area allow for precise resistance to flow. Needle valves are used to control flow into delicate gauges, which might be damaged by sudden surges of fluid under pressure. Needle valves are also used in situations where the flow must be gradually brought to a halt and at other points where precise adjustments of flow are necessary or where a small flow rate is desired. Needle valves are used in almost every industry in an incredibly wide range of applications - anywhere control or metering of steam, air, gas, oil, water or other non-viscous liquids is required. They can be found in every industry from aerospace to zoological sciences, every service from gas and liquid dispensation to instrumentation control and cooling to power generation. However, needle valves should be avoided in applications where the media is viscous, or in the dispensation of slurries. The small flow orifice can easily trap thick materials or solids and become blocked. They can be used as both on/off valves and for throttling service.
Follow Installation Parts Supply® on:

Terms & Conditions | Privacy Policy | Email | Fax 714-842-6684 | Phone 714-842-6680
Plumbing Supplies | Tubing & Hose | Brass Fittings | Stainless Steel Fittings | Oetiker Clamps | John Guest Fittings
Bottle Water Pumps | Beer Equipment | CO2 Regulators for Beer & Soda | Electrical Hardware | Omnipure Water Filters


© 2014 INSTALLATION PARTS SUPPLY® All Rights Reserved.
IPS claims no ownership or rights of listed Logo's, Names or Products other than; IPS, its Company Logo, and INSTALLATIONPARTSSUPPLY.COM®.

Some of the products listed on® may contain chemicals
known to the State of California, Vermont and other states to cause cancer, birth defects or other reproductive harm.
Some of the products, may or may not meet new Federal Laws for AB1953 for lead content.
It is the customers/buyers responsibility to be aware and know all laws pertaining to the use of specific products
IPS is a distributor, not the manufacturer and shall be held harmless of any and all damages including but not limited to:
legal action for misuse, physical, property, water damage or otherwise for any reason. Purchaser/user claims and holds all responsibility.
Some Images are for illustration only and are subject to change according to current inventory and/or Factory Production. Prices subject to change with market.
Customer agrees to all terms and conditions as outlined here and on® Terms and Conditions.

Credit Cards
PCI Compliance

We will pull your order and have it ready for you to pick-up at your convenience (within Will Call hours).
Please allow at least 1 (one) hour to process your order after it has been placed.
(Select "Local Will Call" when prompted to choose a Shipping Method;call us if this option is not available)

Switch to Mobile